AMI NiteHAWK Technical Information Page 67

  • Download
  • Add to my manuals
  • Print
  • Page
    / 87
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 66
Section 3 – Operator Screens
21822706 61
6.9 Audio Modes
The Audio Modes screen is only available in a
jukebox with a Rowe Studio Sound package, a
Rowe 4-Channel Preamplifier or a Rock-Ola Digital
Sybersonic preamplifier installed.
The jukebox has three operating modes
represented by the tabs on this screen; Audio
Mode, Auxiliary Audio Mode, and Standby Mode.
With a Rowe Studio Sound or Rowe 4-Channel
Preamplifier installed, the jukebox will have one
additional mode called Microphone Mode.
The Audio Modes screen allows configuration of
audio signal sourcing, output routing, internal
muting and automatic volume control (AVC) in the
preamplifier for each of the jukebox modes. Touch
any one of the three or four tabs to see and adjust
the configuration for that jukebox mode.
Jukebox Modes:
Standby – This is the mode when a jukebox is not
in any of the other three modes. Basically, a
selection is not playing, Auxiliary Audio is not
enabled, and the paging microphone is not active
(keyed).
Audio This is the mode when a selection (audio
or video) is playing on the jukebox. A selection is
any song being played from the hard drive whether
it is customer-selected, Autoplay, or Background.
The Input Select for Audio mode should always be
mapped to the Sound Card.
Auxiliary Audio This mode is when the jukebox
is not playing an audio or video selection and the
Auxiliary Audio mode is enabled. When in Auxiliary
Audio mode, the preamplifier can be configured to
route an alternate audio source through the
jukebox sound system. Connect the auxiliary
source to one of the other front end inputs, e.g.
Stereo A.
Microphone (Rowe AV Controller or Rowe 4-Channel Preamplifier only) – The preamplifier can be configured to switch the
front end input source to any one of the choices or left Unchanged when the microphone is activated (keyed). The input
source will be heard in the background when the paging microphone is active. When the microphone is turned off, the source
is switched back to the previous setting. The Microphone state is not available with the Rock-Ola preamplifier.
Configurable Options:
Input Select – This section configures which set of RCA jacks on the preamplifier is used for the audio source in each
specific jukebox mode. Normally the jukebox audio from the core computer is plugged into the jacks labeled Stereo
Mechanism Input (Rowe AV controller), Main Stereo (Rowe 4 channel preamplifier), or Main In (Rock-Ola Digital Sybersonic).
Each of these jacks is considered the Sound Card input as far as this configuration setup is concerned. Stereo A, Stereo B or
Mono can be used for audio input for Auxiliary Audio, Standby and Microphone modes. The Microphone Mode tab offers one
additional Input Select choice called Unchanged. Select this option if the preamplifier is not to change its input audio source
whenever a microphone is active (keyed).
Page view 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 86 87

Comments to this Manuals

No comments