AMI NiteHAWK Technical Information download pdf (Page 59)

Section 3 – Operator Screens

21822706 53

6.0 Hardware Setup

6.1 Touch Screen Setup

The Touch Screen Setup screen allows you to set

the refresh rate on the jukebox display and to

calibrate the touch screen.

The Screen Refresh Rate affects the video image on the monitor. This setting may need to be changed due to various

external conditions that can affect the operation and look of the video image. If the image exhibits video noise or a jittery

picture, changing the refresh rate may help improve it.

To change the refresh rate, touch the down arrow at the end of the Screen Refresh Rate text box to display a list of

available settings. Touch one of the settings to change the refresh rate. The screen will immediately change to the selected

setting and a pop-up box will appear asking if you would like to keep the settings. Touch Yes to keep them, or No to revert

back to the previous setting. The screen will automatically revert back to the original setting if you don’t select either option.

Note: Some settings may not look any better, and some settings will not work very well at all. If the screen starts to tear and

you cannot see what is there, just leave it alone for 10 seconds and the screen will automatically return to the previous

setting.

Touch the Calibrate Touch Screen button to launch the touch screen

calibration tool. Make sure you are viewing the touch screen from the same

position a customer would view it during normal use.

1. Touch the center of the first target, holding your finger on the target

for approximately two seconds. When you release your finger,

another target will appear in a different corner.

2. Touch the center of the second target for two seconds and upon

release, the third target will appear.

3. Touch the center of the third target and hold it there for two

seconds.

4. After touching all three targets, a confirmation screen will appear.

Touch the screen in various places to make sure the cursor jumps to

your fingertips.

5. If the cursor follows your finger accurately, touch Yes. If it does not,

touch No and the calibration tool will restart.

To return to the Service Mode – Main Menu, touch the Back button.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 86 87

No comments

AMI NiteHAWK Technical Information Page 59